6
Assembly Instructions
Wall Mounted Filtered
Water Cooler
Attach mounting bracket to wall
Note:
To comply with ADA requirements, the base of stencil must be
installed 11" to 14
3
/
4
" from the floor. See Rough-in Guide for additional
ADA requirements.
Note:
Before installing bracket to the wall, check location of power source,
water line and drain.
• Affix stencil with tape to appropriate wall. It is recommended to use a level
to ensure the stencil is hung straight horizontally.
• Drill (6) holes appropriate for the wall anchors (75 lb. minimum each)
as indicated on the mounting bracket on the stencil. Use appropriate
anchors for your wall type.
• Drill (2) holes appropriate for the wall anchors (75 lb. minimum each) as
indicated on the bottom support holes on the stencil. Use appropriate
anchors for your wall type.
• Remove stencil from the wall and install bracket onto the wall using
appropriate anchors.
4
5
CAUTION
Hanging assembled unit to wall
Carefully hang assembled unit onto the
wall by lowering onto mounting bracket.
WARNING
installation of
equipment should be
performed by 2 people.
6
Valve Control
•
Ensure water control valves are turned to the
closed position.
• Attach 2 screws (not included) through the frame
of the Cooling System and into the bottom
support holes previously drilled into the wall.
• Connect the buildings water supply to the Filter
Head Connection. This connection must be made
through the back of the Cooling System.
• Connect the internal drain line to the building's
external drain. This connection must be made
through the back of the Cooling System.
Closed
Closed
Connect filter head
to water supply
Lift Points
Water control valves
Wall mounting
hardware not provided
Always wear work
gloves when lifting
Level
Mounting
Bracket
Note:
If cooling system is on its side or back for more than
10 minutes, allow it to stand in the upright position for
24 hours before water connections and initial power-on.
