Mounting Position
The Carbon Infrared Sole Heater must be
installed paying special attention to the
minimum clearances stated in these
instructions. The heater must be mounted on
a rigid fixture; ideally on a ceiling directly
above the area to be heated. If this is not
possible, the heater can be mounted on a
wall and angled downwards.
Recommended installation height should be
between
83” to 106” from the floor. DO NOT
install the unit less than 71” from the floor. In
all cases it should be installed at a height
where it cannot be touched during operation.
NOTE:
Wall/ceiling mount swivel brackets and accessories are included with the heater which has
been specifically designed to allow this product to be fitted to a wall or ceiling with adequate
clearances (
5.5”) at the back of the unit. The sides and ends of the heater must be positioned at least
12” away from the nearest wall or other surface.
Installation:
Mounting Hardware Includes:
• 4 x Bracket Pieces - Fit together to form 2 brackets with central pivot
• 4 x Bolts with Expansion Plugs - For mounting brackets onto ceiling or wall
• 2 x Slider Plates - Fit into grooves on rear of heater
• 4 x Small Bolts – For attaching the brackets onto slider plates
• 4 x Small Bolts with Nuts – To form the pivot on the brackets
• 2 x Screws - To clamp the slider plate in position on the heater
