Replacement kits are available from your distributor. Kits
include (2) heating elements, (2) PTFE adhesives, (2) PTFE
covers. Optional round wires are available for seal and cut
applications (shrink wrapping, etc).
To install your replacement kit on your sealer, turn off power
and unplug sealer.
Removing Worn Parts
· Loosen the screws on the PTFE cover plate and remove the
PTFE cover.
· Remove the PTFE cover to expose the heating element.
· Remove the heating element by lifting off the eyelets of the
heating element from the mounting spring on both ends.
· Peel off the PTFE adhesive under the heating element.
Installing New Replacement Parts
· Remove the backing of the liner on the PTFE adhesive.
· Apply it to the sealer’s sealing platform. The PTFE adhesive
must always extend past the sealing platform by approximately
¼” to ½” on both ends. Bend down the excess on both ends.
(The PTFE adhesive acts a barrier between the metal body
and the heating element. Never allow the heating element to
come in direct contact with the sealer’s body because it will
damage the timer.)
pa
ge 10
pa
ge 11
· Place a new heating element on top of the PTFE adhesive by
fitting one eyelet of the heating element on one mounting
spring followed by the other mounting spring. Using a
screwdriver to flex the mounting spring inward will ease the
placement of the element on the mounting spring. Check the
element to ensure it is tight and intact.
· Place a new PTFE cover on top of the heating element.
· Tighten the screws to affix the PTFE cover plate.
