Global American 3308290, User Manual

Page: 87 / 105

Page 87
Step 3: Insert the DIMM
. Once properly aligned, the DIMM can be inserted into the
socket. As the DIMM is inserted, the white handles on the side of the socket will
close automatically and secure the DIMM to the socket.
Step 4: Removing a DIMM
. To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the socket.
Step 0:
5.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 5-8: Jumper Locations
Before the 3308290 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the 3308290 are listed below.
Description Label Type
CF card setup JCF1 3-pin header
Clear CMOS J_CMOS1 3-pin header
COM 1/2 Pin 9 setting JP1 10-pin header
LVDS voltage selection J_LVDS1 3-pin header
LVDS screen resolution selection JP3 8-pin header
PCIe x16 / SDVO selection J1 & JSDVO1 2-pin headers
Table 5-1: Jumpers