Hardware Configuration Setting
3303788
User’s Manual
2-3
JP6
1 – 2 : Connect WDT output to system reset
!
2 – 3 : Connect WDT output to NMI
JP9
WDT Time-out Interval (Twd) settings
5-6 3-4 1-2 Time-out Interval (Twd)
Short Short Short
0.5 sec.
Short Short NC
1 sec.
!
Short NC Short
2 sec.
Short NC NC
4 sec.
NC Short Short
8 sec.
NC Short NC
16 sec.
NC NC Short
32 sec.
NC NC NC
64 sec.
JP7
WDT Time-out sources :
1 – 2 : initiated from hardware WDT by setting JP9
!
2 – 3 : initiated from software WDT by programming super I/O chipset
W83977ATF
RTC CMOS Clear Jumper Setting (JP2)
JP2
NC : Normal operation
!
Short : Clear CMOS contents
NOTE : This CMOS clearing operation can be done under system power on if
CMOS RAM CLEAR FUNCTION does not exist in Advanced
Chipset Setup. It also can be done under system power on or off.
However please make sure that the CMOS RAM clear option has
been enabled in Advanced Chipset Setup before CMOS clearing
happens.
AT/ATX Power Supply Selection (JP3)
JP3
1 – 2 : Select ATX power supply
2 – 3 : Select AT power supply
!
