Cable connection to Switch & ACC power
Connect the switch cable to the switch
terminal on the control box.
When starting the motorcycle, connect the ACC+ line (which is included with the switch
cable) to the power line.
2
Run the switch cable along the line inside the
motorcycle cover or fuel tank to the handlebar.
Position the switch wire so that it cannot be seen
from the outside of the motorcycle.
Secure the switch to the handlebar.
※
Fix the switch according to the user's
convenience.
(Left/Right, Up/Down)
4
3
Tip.
First, pass a thin wire through the inside of the motorcycle, and then
weave the switch cable to the wire in the handle part.
Connect the switch cable to the control box by pulling the wire back into
the interior of the motorcycle.
Tip.
Tightening the switch wire may cause the wire to break when the handle
is moved. Please take your time and work.
1
※
In the case of Honda Goldwing, the
battery and ACC+ wire are located
inside the side cover of the motorcycle.
※
The ACC+ line is located differently
depending on the motorcycle model.
For more details, please check the
manufacturer's manual.
21
※
When the motorcycle ignition is off, the FLEX GEAR
should not operate.
