Glidermatic™
Commercial Door Operator
User Manual
1
Important Safety Instructions
•
DO NOT operate unless the door is completely visible and clear of obstructions including children, persons,
vehicles or other objects. SEVERE PERSONAL INJURY, property damage or even DEATH may result if this
warning is not followed
•
DO NOT operate the door if children or persons are near the opening. Children must always be supervised
when near the door at all times the operator is in use
•
DO NOT allow children to operate the door. SEVERE PERSONAL INJURY, property damage or even
DEATH may result if this warning is not followed.
•
The SAFETY REVERSING function should be tested on a monthly basis to ensure it is set correctly and
the door will reverse on its downward motion when an obstruction is encountered. If this function does not
operate DISCONTINUE USE and contact a qualifi ed service technician.
•
If additional SAFETY is required, it is STRONGLY recommended that a Photo Electric Cell or Sensing Edge
device be installed. It is mandatory that such devices be used in conjunction with radio control units or
when momentary contact on close function is enabled.
•
When the Automatic Close function or Radio Transmitters are being used, a Sensing Edge or Photo
Electric Cell must be correctly fi tted and tested on a regular basis. If SAFETY features do not operate
correctly, DISCONTINUE USE and contact a qualifi ed service technician.
•
When possible activate the manual release only when the door is closed. Weak or broken springs may
allow the door to fall rapidly, causing SEVERE INJURY or even DEATH. In all cases stand clear of the door.
In the event that the door appears to fall, a qualifi ed service technician will be required to adjust the spring
tension.
•
Install the control unit on the same side of the door as the drive unit with an uninterrupted view of the door
and opening. The control unit should be installed in a suitable location to ensure it is protected from the
elements. Under NO CIRCUMSTANCES should the unit be exposed to water.
•
When installing the operator on an existing door, ensure it is good operating order. Ensure the springs are
not weak or broken and the door is free of sticking or binding. Contact a qualifi ed service technician for
attention to any of these issues.
•
If any wiring is damaged, it MUST BE replaced by a qualifi ed service technician in accordance with the
manufacturer’s detail.
•
Ensure the door is completely open before proceeding through the doorway.
www.garagedoorsonline.co.uk
01926 463888
