Radio Control Wiring
In order to operate the door with a wireless remote, an independent
Radio Control Unit
may be installed and
connected to the Glidermatic control unit.
Always disconnect power to unit BEFORE making any setting changes.
CAUTION:
Glidermatic™
Commercial Door Operator
User Manual
11
Gr
ound
+V
Single
STOP
DOWN
UP
It is essential that a supplementary safety device such as a
Sensing Edge or Photo Electric Cell
be
fi tted when radio control unit is installed to prevent injury or entrapment
Power to the receiver is supplied from terminals
5
&
6
of
J3
5
is
+v, 6
is
ground
Ensure Jumper
JP2
is confi gured to match
required voltage of
radio control receiver
. (5,
12 or 24VDC)
Single (Up/Down) Output Type Receiver
Connect output of receiver to terminal
4
of
J3
Open/Close/Stop Type
Receiver
Connect terminals Up, Down and
Stop of Radio Control Receiver to
1, 2
&
3
respectively
Ensure the jumper
JP4
Latch terminal is set to
ON
Edge
jumper
JP3
is set to
N/O or N/C
Pcell
jumper
JP3
is set to
N/O or N/C
In accordance with the instructions supplied by the
manufacturer of the supplementary safety system
Once any radio receiver unit is connected the unit will not operate unless a supplementary safety device is
fi tted and the jumpers at
JP3
and
JP5
set accordingly. Refer to pages 9 and 10.
www.garagedoorsonline.co.uk
01926 463888
