NOTICE ON REINFORCING STRUTS
#1
#1
If your door is over 4.56 metres wide it would be supplied
with reinforcing struts. Struts are placed as follows
Doors 4.56m – 4.87m one strut only top panel,
near top if automatic.
Doors 4.87m and over struts on all hinged sections.
Fig. 7
Step 8
As each door section is completed, the rollers must be placed
in the brackets and hinges as shown in Fig. 8. Once complete
slide bottom panel into vertical tracks, (refer Fig. 9), ensure
rollers are engage in track and moving freely.
Fig. 8
Step 9
Check that door panel is level by placing spirit level on top
edge of door panel. If panel is not horizontally level it may be
necessary to use suitable packer underneath door panel to
achieve level.
Make sure vertical tracks are level.
Fig. 9
Step 12
Place the last section face down, attach the top corner
brackets to the door panel as shown in Fig. 12. The top
brackets are secured using four tek screws. If the door is
supplied with reinforcement struts, attach the strut as shown
(inset). Do not install final panel until Step 17.
Fig. 12
#1
#3
Step 11
Repeat step 10 using number 3 hinges on the third door
panel. Ensure number 1 hinges are used one each internal
vertical rigid section.
NOTE: If your Panel-Glide has more than four door panels it
will be necessary to repeat the process again using number
four hinges before proceeding to step 12.
Fig. 11
#1
#2
Step 10
Place the next door panel face down on the supports, attach
the number 2 hinge to each end of the door panel. Attach
the number 1 hinge to each vertical rigid section between
the two outer hinges. Lower this door panel onto the first
panel.
Fig. 10
Reinforcing
strut
