GliderGuider
USER GUIDE
28
www.gliderguider.net
Tap on “Port Settings” and set the COM
Port to match that which you set earlier
(COM9 in this example).
Note the other Com Port settings. These
may vary according to your individual
Bluetooth device.
Tap ok to accept the settings and then
“Terminal” to run the terminal emulator.
If all is well, the Terminal screen should
quickly fill with valid NMEA data
– like that
shown on the left.
The Com Port and Settings are shown on
the top right (COM9:9600,N,8,1 in this
example).
Note: An empty screen indicates that the
assigned Com Port is open, but that there
is a no data present, while an error
message (e.g.
“mcu failed!”) indicates that
the assigned Com Port is not available.
