Always disconnect from the mains, when the device is not in use or beforecleaning it.
For overhead use (mounting height > 100cm), always fix it with at least 1 safety rope
that
.
Keep away children and amateurs from the device! Never leave the device running
unattended!
Please note that damages caused by manual modifications on the device or unau-
thorized operation by unqualified persons are not subject to warranty.
This device is a moving head wash for creating decorative effects for discotheques,
stages etc. It is allowed to be operated with an alternating current of 100-250V 50/60
Hz, and is designed for indoor use only.
Operate the device only after having familiarized with its functions. Check the device
carefully to see if the housing is firmly closed and with all screws tightly fastened.
Never run the device without a lamp! The lamp must never be ignited if the objective-
lens or housing is open, as the discharge lamp might explose and emit a
Do not shake the device. Avoid brute force when installing or operating.
Never lift the device by holding its projector-head, as the mechanics may be dama-
ged. Always hold the device at the transportation handles.
When choosing the installation-spot, please make sure that the device is not expo-
sed to extreme heat, moisture or dust. There should not be any cables lying around.
You endanger your own and the safety of others!
The min. distance between the device and illuminated surface is 1 meter.
Make sure that the area below the installation place is blocked when rigging, derig-
ging or servicing the device.
OPERATING DETERMINATIONS
During the initial start-up some smoke or smell may arise. This is a normal process
and does not necessarily mean that the device is defective.
During its operation the housing of the device becomes hot (even as high as 120 C)!
Do not touch the device bare hands.
For replacement, use same type and rating lamp or fuse only.
can hold at least 10 times the weight of the device
high ultra-
violet radiation, which may cause burns.
o
- 2 -
- 11 -
CAUTION! EYEDAMAGES!
Avoid looking direct to the light source (meant
especially for epileptics)!
!
!
Reset
DMX CHANNEL
Press the Menu button to back
to the main menu.
Press the Menu button once
again.
Press Up or Down button to
select the second icon (Setup)
on the second line.
Press the Enter button.
Press the Up or Down button
to select the RESET.
Press the Enter button, you will see YES in the right highlighted.
Press the Enter button to save your setting. The device will start to RESET once.
By the Setup menu you may make many customerized settings,
Fader Delay, ON or OFF.
Signal Link, ON or OFF.
Code Wheel, ON or OFF.
Screen Saver, On or OFF.
Factory Defalt Set.
ou need to assign a DMX start address for all devi-
ces in the DMX chain. See page 5.
This device has 14 channels. See next page.
Other useful setting
This device has 3 working modes, DMX mode, Auto mode and Sound mode.
See page 7.
See page 8.
In DMX mode you can connect more than one device to build a DMX chain and control
all devices via a DMX controller. Y
To set the device work in DMX mode, see page 7.
OPERATION
1. Working modes
2. Auto mode
3. Sound mode
4. DMX mode
ON
ON
ON
ON
OFF
ON
070
070
YES
TemperatureSet
DisplayReverse
DisplayReverse
TemperatureSet
TempSwitchSet
TempSwitchSet
ScreenSaver
ScreenSaver
FactorySet
FactorySet
RESET
RESET
SetUp
SetUp
