AP72-01 Page 7 Issue 6
RESULT CODES
When a command is issued, the GSGC6 responds with a result code (either OK or
ERROR) to indicate whether it understands and can act on the instructions. Result Codes also
report the progress of a connection.
Word
Meaning
OK
Command executed
CONNECT
CONNECT B1
Connect
CONNECT B2
Connect
RING
Ring signal detected
NO CARRIER
Carrier lost or never detected
ERROR
Invalid command entered
BUSY
No available channel
DTMF 'n'
DTMF received
FRAMED
Codec frame found
SEARCH
Codec searching for frame
NVRAM ERROR
Error in reading or writing to Non-Volatile memory
UNKNOWN
Codec Mode not known
G722
Codec Mode = G722
MPEG
Codec Mode = MPEG
APTX
Codec Mode = APTX
0k
Sample frequency not known
16k
Sample Frequency = 16KHz
24k
Sample Frequency = 24KHz
32k
Sample Frequency = 32KHz
48k
Sample Frequency = 48KHz
56k
Data Rate = 56KBits/Sec
64k
Data Rate = 64KBits/Sec
S REGISTERS
The S registers are used to store various operating characteristics of the Terminal
Adaptor. The following registers can be modified if necessary. To modify the contents of the
S registers, use the ATSn=m command where n is the register number and m is the new
decimal value. To view the contents of an S register, use the ATSn? command where n is the S
register number.
S0
Answer On Ring Number
Default:
0
Range:
0-255
Register S0 is set to the number of rings that the Terminal Adaptor should wait before
answering. Setting this register to 0 will disable the auto answer function.
