Control Panel Operations
Directions for use
Caution: Before using the water heater, make sure that it should be
completely filled with water.
The wireless remote works with one CR 2025/3V CELL.
Ensure that the wireless remote does not get in direct contact with water.
Do not operate the remote with wet hands.
Initial power
When the water heater power supply plug is connected, it is in initial
power on state. The led display on the control panel will glow and
goes off as shown in Fig. 3.
Power ON/OFF
To switch on/off the water heater press ON/OFF key on the control
panel or “ “ on wireless remote. While switched on the LED
display shows actual temperature of the water as shown in Fig. 4.
Note: The heating indicator glows when the heating element in
switched on.
Temperature setting
Press “ “ (Increase), “ “ (Decrease) keys to adjust the Set Temperature.
Set temperature increases or decreases by 1
o
C for each press from
25
o
C to 75
o
C. Wait for few seconds the value flashes for 5 times and
the new temperature value is stored. The set temperature scrolls on
pressing the keys continuously for 3 sec. The LED display glow as
shown in Fig. 5.
Note: The water is heated to the new stored temperature until the
temperature setting is changed.
Operation of remote control
The operating method and function keys of the remote control as shown in Fig. 2.
1. Prior to operating the remote control, it is necessary to install the battery.
2. While the remote control in use, point it at the electronic controller, having a
range within 50 m.
Note:
•
Replace the batteries if the controller does not function correctly.
•
Use one CR 2025/3V cell. Ensure to insert them in the correct orientation.
•
When replacing the batteries, do not mix old and new or batteries of a
different type.
•
If the remote is not used for a long period, please remove the batteries.
Fig.3
Fig.2
Fig.5
Fig.4
Noted: Please long press “Reset” button three seconds for match code when the
machine first time connect with electricity within 15 seconds. The remote
control would be functional after completion of match code. Kindly double
match code as before when the battery replacement.
Indicator glows when
the “warm” is progress.
To decrease the set
temperature. (When the
Auto ON is pressed).
Indicator glows when the
“heating” is progress.
To Switch ON/OFF the
heater. While switched
on the display shows the
water temperature.
To increase the set
temperature. (When the
Auto ON is pressed.)
To switch ON/OFF the
heater. While switched
on the display shows the
water temperature.
To increase the set
temperature.
(When the Auto ON
is pressed.)
Top decrease the set
temperature.
(When the Auto ON
is pressed.)