ERROR CODES
Heater display
Fault
Action
F0
Touch control
software error.
If error has occurred after initial cali-
bration (see initial power on) discon-
nect and reconnect the power from the
hob again, re-calibrate the hob again,
if the error persists or appears again in
normal use, call customer services.
Fc or F
Touch control is
too hot and has
turned off the
heaters.
Wait until the temperature goes down.
Hob will automatically start again once
it reaches normal temperature.
You may have to switch the power off
and on to reset the fault code.
Ft
Touch control
temperature
sensor may be
damaged.
Wait until the temperature goes down.
If the message persists after the hob
cools down call customer service.
FE
Touch control
temperature
sensor may be
damaged.
Wait until the temperature goes down.
If the message persists after the hob
cools down call customer service.
FL
Extreme ambient
light conditions
on initial set-up.
See initial power on to resolve.
FJ
Security soft-
ware error
This error is a software auto check. It
disappears when auto-check returns to
normal value, If error persits call cus-
tomer service.
FU
Security soft-
ware error.
This error is a software auto check. It
disappears when auto-check returns to
normal value, If error persits call cus-
tomer service.
FA
Security soft-
ware error.
This error is a software auto check. It
disappears when auto-check returns to
normal value, If error persits call cus-
tomer service.
Fr
Relay operation.
This error is an autocheck for the mi-
croprocessor signals that control the
heater relays operation. Disconnect the
hob to the main switch, wait several
seconds and connect again. Program
the hob as usual. If the error persists,
call customer service.
