PG 16
PG 17
Make sure that the water supply is turned on to full pressure. Open the door, press the "Power" button, Press the "program." button
to select a desired "Wash cycle". (See the section entitled "Wash Cycle Table".)
With a little force to ensure the door is properly closed.
NOTE:
A click will be heard when the door is closed perfectly. When the washing is over, you can shut off the switch by pressing “
Power “ button.
Change the Programme.
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already drained the wash water. If this is the
case, the detergent dispenser must be refilled (see the section entitled “ Fill in the Detergent“).
Open the door, Press current programme button for more than three seconds to cancel the programme, then you can change the
programme to the desired cycle setting (see the section entitled “Starting a wash cycle. . . “ ). Then, close the door.
NOTE
: If you open the door when washing, the machine pauses and warning alarm rings, the display appears E1. When you close the
door, the machine will keep on working after 10 seconds.
The 6 programme lights show the state of the dishwasher:
a) All program lights off --> stand by
b) One of the program lights on --> cycle running
c) One of the program lights blinking --> pause
Forget to Add Dish
A forgotten dish can be added any time before the detergent dispenser opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add forgotten dishes.
4. Close the door, the dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears “---” and the buzzer rings 6 times, only in this case the programme has ended.
1. Switch off the dishwasher by pressing the “ Power “ button.
2. Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
• Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes before removing
from the appliance.
• Open the dishwasher’s door, leave it ajar and wait a few minutes before removing the dishes. In this way they will be cooler and
the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside. Empty the lower basket first and then the upper one. This will avoid water dripping
from the upper basket onto the dishes in the lower one.
7. MAINTENANCE AND CLEANING
The filter is used to avoid the big remnants and other sundries getting inside the pump. The residue can obstruct the filter in
overtime.
The filter system consists of a coarse filter, a flat (Main filter) and a
micro filter (fine filter).
1 Flat filter
Food and debris will be trapped by a special jet on the lower spray
arm.
2 Coarse filter
Big debris, such as bone and glass that could clog the drain will be
trapped in the coarse filter.
To remove an item caught in this filter, gently squeeze the taps on
the top of this filter and lift it out.
3 Micro filter
This filter holds soil and food residue in the sump area and prevents
it from being redeposit on the dishes during a cycle.
- Inspect the filters for obstructions every time the dishwasher has
been used.
- By unscrewing the coarse filter, you can remove the filter system.
Remove any food remnants and clean the filters under running water.
Step 1 contrarotate the
Coarse filter ,and then lift it up;
Step 2 lift the Flat filter up
NOTE:
If operate from step 1 to step 2, the filter system will be removed; while operate from step 2 to step 1, the filter system will
be installed.
Filter assembly
For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash
water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in
the filter after each wash cycle by rinsing the semicircular filter and cup under running water. To remove the filter assembly, pull on
the cup handle in the upward direction. The entire filter assembly should be cleaned once a week. To clean the coarse filter and the
micro filter, use a cleaning brush. Then, reassemble the filter parts as shown in the figures above and reinsert the entire assembly
in the dishwasher, positioning in its seat and pressing downward. The dishwasher must never be used without the filters. Improper
replacement of the filter may reduce the performance level of the appliance and damage dishes and utensils.
