32 /48 EN
Dishwasher / User’s Manual
Operating the product
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
End of Programme indicator will light up when the
washing programme is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your machine.
3. Close the tap.
4. Unplug the machine from the socket.
C
For energy saving, the machine
is automatically turned off
following the completion of the
programme or if the programme
is not started.
C
Leave your dishes in the machine
for about 15 minutes to allow
them cool down after they are
washed. Your dishes will dry in a
shorter time if you leave the door
of your machine ajar during this
period. This process will increase
the drying effectiveness of your
machine.
Water cut-off warning
If mains water is cut or water inlet tap is turned
off the machine cannot take water in and E:02
icon will flash on the programme indicator. As long
as the problem continues, washing programme
is paused and the water inlet is checked regularly
by the machine; when the water is restored E:02
icon will disappear after a while and the washing
programme resumes.
Overflowing warning
If the machine intakes too much water or there
is leakage at any of the components then
the machine will detect this and E:01 icon will
flash on the Programme indicator. As long as
the overflowing continues safety algorithm
will be active and try to discharge the water. If
overflowing stops and safety is assured, E:01 icon
will disappear. If E:01 does not disappear, there
is a permanent fault. In this case the authorised
service should be contacted.
Adjusting the amount of
rinse aid
1. After turning on the machine, press
Time Delay and P+ keys simultaneously.
After the countdown (3, 2, 1) is
displayed keep the keys pressed for a
while.
2. Press P+ to move to position (P) on the
display.
3. Set to the appropriate level with the
Time Delay key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
End of programme
C
When the programme you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine.
This audible signal will warn you
with certain intervals before it
turns off.
