Before servicing
- disconnect the gas
and electric supplies.
After servicing
- Check for gas soundness.
Note:
The control system only allows gas
to flow when back panel is in place and
fully screwed home. Oven or grill should
only be operated with all panels in place.
1. Facia glass panel
a. Remove appliance from housing (2)
and remove the top & RH side panel.
b. Unplug the programmer connection.
c.
Support the facia, remove the 2
securing screws (one each side).
2. Remove appliance from housing
a. Unscrew securing screws in the front
frame & slide the appliance forward
on to a table.
b. Disconnect the gas and electricity
supplies is necessary.
3. Door glass panel
a. Open the door and insert 2 screws
through the inner holes in the door
hinge arms (to stop the door from
springing up when you remove the
outer glass panel).
b. Slide out the inner glass panel.
c.
Remove 2 plastic inner glass stops at
bottom of door extrusion.
d. The door foot can be withdrawn
completely from door extrusion.
Important:
The inner glass panel
must be replaced the right way up as
shown (the reflective side faces
inwards) and also pushed fully into the
stop position.
4. Oven Light bulb
a. Remove the oven shelves.
b. Grasp the back edge of the light cover
and pull forward.
c.
Unscrew the bulb.
5. Top and rear compartment
access
a. Remove the appliance from housing
unit (2).
b. Unscrew and remove top plate screws.
c.
For rear compartment access, remove
top panel first.
6. Oven igniter electrode
a. Inside the oven - remove the fan cover.
b. It may be necessary to remove the
burner (7) to remove the screws
holding the igniter bracket.
SERVICING INSTRUCTIONS
33
SLIDE
IN
SLIDE
IN
THIS SIDE UP
Summary of Contents for 900gr
Page 1: ......
