11
Installing the ventilation pipe
Once the cooker hood is installed, install the ventilation pipe.
1. Get ready the two covers, “A” and “B”.
2. Place the bottom part of cover “A” on the top of the cooker hood, making sure to correctly position the fastening points
on the cover, marked “X” (see Fig. 7), against the back of the cooker hood.
3. Install cover “A” on the cooker hood using the two bolts, “K”, supplied in the accessories pouch (Fig. 7).
4. Lift the moving cover, “B”, up to the ceiling. Make sure the hood is in a perpendicular position.
5. Mark the side position of the moving cover, “B”, and let it slide down (see Fig. 8).
6. Take the fastening support, “G”, (Fig. 7, previous page), centre it (using the marks) while it touches the ceiling and
mark the position of the anchoring holes, “H”.
7. Drill the holes in the wall in the places marked, using a 6 mm drill bit (see Fig. 9).
8. Insert the dowel pins into the holes, put the support, “G”, in position (Fig. 7, previous page) and fasten it using the bolts
supplied.
9. Lift cover “B” up to the ceiling and fasten it to the support, “G”, by inserting the bolts into the holes, “M” (Fig. 7,
previous page).
Fig. 7
Fig. 6
Summary of Contents for GHB970IX
