gledhill ElectraMate 2000, Installation And Servicing Instructions

Page: 3 / 44

Supplied By www.heating spares.co Tel. 0161 620 6677
Page 3
ELECTR
AMA
TE
2000
1.0 DESIGN
1.1 INTRODUCTION
Any water distribution and central heating
installation must comply with the relevant
recommendations of the current version of
the Regulations and British Standards listed
below:-
Building Regulations
I.E.E. Requirements for Electrical Installations
- BS 7671 : 1992
Water Regulations
British Standards
BS6798, BS5449, BS5546, BS5440:1, BS5440:2,
CP331:3, BS6700, BS5258, BS7593 and BS7671.
Although the domestic water supply to the
ElectraMate 2000 is at mains pressure, it is not
necessary to fit an expansion vessel, pressure
or temperature relief valve.
The ElectraMate 2000 is available for use with
sealed primary central heating systems.
The manufacturers notes must not be taken as
overriding statutory obligations.
The ElectraMate 2000 is not covered by section
G3 of the current Building Regulations and is
therefore not notifiable to Building Control.
The information in this manual is provided to
assist generally in the selection of equipment.
The responsibility for the selection and
specification of the equipment must however
remain that of the customer and any Designers
or Consultants concerned with the design and
installation.
Please Note: We do not therefore accept any
responsibility for matters of design, selection
or specification or for the effectiveness of an
installation containing one of our products
unless we have been specifically requested
to do so.
All goods are sold subject to our Conditions
of Sale, which are set out at the rear of this
manual.
In the interest of continuously improving the
ElectraMate range, Gledhill Water Storage
Ltd reserve the right to modify the product
without notice, and in these circumstances
this document, which is accurate at the time
of printing, should be disregarded. It will
however be updated as soon as possible after
the change has occurred.