![GLD Products VIPER 850 Manual Download Page 8](http://html.mh-extra.com/html/gld-products/viper-850/viper-850_manual_2231129008.webp)
GLD Products
Viper Dartboard
Item 42-1060
8
1-800-225-7593
www.gldproducts.com
Create the Toe Line
Place a toe line 96" from the face of the board for the throwing distance. Adhesive tape
or masking tape, 2' long by 2-1/2" wide, may be used. GLD Products also offers a Viper
Throwing Line and a Dart Mat for this purpose.
POWER INSTALLATION
The dartboard is designed to be powered by an AC to 5V DC, 1000 milliamp (minimum)
adapter, with the DC plug polarity con! gured as positive (+) outside, and negative (-)
center. To connect the adapter, plug the DC plug into the DC power jack on the dartboard
and the AC plug into an electrical outlet.
1. The board is not intended for children under the age of 9 years old.
2. The board must only be used with the recommended transformer.
3. The transformer is not a toy.
4. Disconnect the dartboard from the transformer before cleaning.
PROTECTIVE FILM
This electronic dartboard has a clear protective ! lm over the entire display and button
area to prevent scratching during shipping. It is recommended that you remove this ! lm for
easier reading of the display. To remove, simply lift edge, peel off and discard.
WARNING: Not for use by children without adult supervision.
Darts are not toys and may cause injury if used
improperly. Everyone must stand behind the dart
thrower.
IMPORTANT NOTES
1. During shipping or in the course of normal play, it is possible for scoring segments of this
board to become temporarily jammed, resulting in a “frozen” board. If this occurs, the built-
in
Self Diagnostic Function
of the e-BOARD Computer will be activated automatically.
Your dartboard will run a self-test routine to determine which segment is stuck. An error
message will appear on the display together with the description for the “Frozen” button or
segment.
a. Find the “frozen” segment according to the display.
b. Press ! rmly down on the “frozen” segment until it breaks free and the loose ! t is
restored. Once the “frozen” segments are loosened, the error message should be
gone and the board will continue to operate normally.