GLD Products
Showdown Dartboard
Item 42-0002
6
1-800-225-7593
www.gldproducts.com
Mounting Using the Keyhole Slots
Refer to the illustrations on the following pages.
1.
Choose a location that has at least 10 feet of open ! oor space in front of the board.
Locate and use a wall stud for mounting whenever possible.
2. Locate studs and use wood screws or sheet metal screws to secure the dartboard if the
mark is on the stud. The head of the screw must be smaller than 3/8" and larger than 1/4".
3. Determine the location for the dartboard. Place a mark on the wall 68 inches (172.7 cm)
from the ! oor. This mark is the # nal position of the center of the dartboard (bullseye).
4. If the mark is not over a stud, use the mounting hardware that came with your
dartboard.
5. Measure 8-5/8" (21.9 cm) directly up from the bullseye mark and place a mark on the
wall. Then measure down 8-5/8" (21.9 cm) from the bullseye mark and place a mark on
the wall. Use a level to check that all marks are vertical.
6. Drill pilot holes at the two marks. These are for the mounting screws.
7. If using wall anchors, follow the instructions under Wall Anchors on page 5.
8. Insert screws into anchors until a 1/4" (6.5 mm) gap is left between the wall and the
screw head.
9. Hold the dartboard so the two screw heads # t into the lower part of the keyholes. The
dartboard should slide down 1/2 inch and the screw heads will hold it on the wall.
10. Screws can be tightened or loosened to provide a secure mounting.
Mounting Using the Four Holes From the Front
Refer to the illustrations on the following pages.
1. Choose a location that has at least 10 feet of open ! oor space in front of the board.
Locate and use a wall stud for mounting whenever possible.
2. Two people are needed for this step. Hold board on the wall. Position center of bullseye
68" from the ! oor. Level the board. Hold in place.
3. Locate the four mounting holes on the front of the board. Use a marker or nail to mark
the position of the board through the four mounting holes onto the wall. Remove the
board.
4. Drill four pilot holes on the marks created in Step 3.
5. If using plastic anchors: drill the holes so the anchors # t snugly. Push anchors into
place.
6. Line up dartboard over anchors. Screw board into place. The screws will expand the
anchors.