Glatz AMBIENTE, Fitting And Operating Instructions

Page: 16 / 40

4
1
2
3
7
5
6
4
1
2
5
3
|
16
3. FITTING
3.1 Fitting the support tube into the ground socket / movable base
(Fitting the support tube into the movable base works analogously to
the instructions for the ground socket stated below.)
• Remove cover (2) from ground socket (1).
• Unscrew support tube (3) from the sunshade mast by unscrewing
the bolts (4) (if necessary pull the electric cables out of the ground
socket through the support tube and fit the plugs).
• Place the support tube (3) on the ground socket and align the notch
(5) to the seating area.
• Insert the 5 anchoring screws (6).
• Lower the cover plate (7) onto the support tube ring.
3.2 Setting the sunshade (2 persons are necessary for this)
• If necessary, plug together the electrical connections, screw them
together and stow the cable away in the support tube and mast.
• Lift the sunshade (A) to an angle of approx. 30º and place the lower
end of the mast on the support tube (3).
• Raise the sunshade carefully further until the mast slips down over
the support tube
• Insert the connecting bolts (4).
• Undo the fastening belt (2) from the sunshade and pull outwards
cloth and roofstruts for pre-spreading the shade.
• Insert crank handle (C) into the opening of the mast, turn the crank
handle in a clockwise direction and open the sunshade completely
up to the stop.
• Check the correct position of the sunshade.
EN EN
Fig. 2 Fig. 3