![background image](http://html1.mh-extra.com/html/glasdon/electra-bin/electra-bin_operator-instructions_2230668003.webp)
ELECTRA
®
BIN
Operator Instruction Leaflet
12.
Place the bin in the desired location.
Inspect the condition of the concrete you
wish to install in to. If installing into paving
slabs- ensure fixings are not positioned
within 110mm of the edge of a slab (as
doing so may cause the slab to break).
13.
Move the bin to one side to
allow the holes to be drilled.
Ensure the holes are clearly
visible.
Mark the positions of the
four ground fixing holes in
the base of the bin onto the
concrete base below using
a marker pen.
11.
KIT CONTENTS:
ITEM 1 - Anchor Rawl Plug
x 4
ITEM 2 - Screw (M10 x 60mm) x 4
ITEM 3 - M10 x 50mm Washer x 4
14.
Using a powerful drill - drill the four
16mm diameter fixing holes to a
minimum depth of 80mm. Afterwards,
take care to ensure the concrete dust
is removed from the holes using an air
blower or sweeping brush.
15.
Take the four Anchor Rawl
Plugs (ITEM 1) and using a
hammer gently tap them
into the four ground fixing
holes.
16.
Place the bin back into
position. Take care to align
the ground fixing holes.
3
17.
Take the M10 Screws (ITEM 2) and
Washers (ITEM 3) and fit them
through the base of the bin and
into the ground anchor sleeves fit-
ted into the concrete.
18.
Tighten the M10 Screws using a
Socket Wrench fitted with a17mm
Socket or 17mm Spanner -
(maximum recommended torque
setting is 40Nm).
TOOLS REQUIRED:
Marker Pen
Drill with
Ø
16mm Masonry Drill Bit
Hammer
17mm Socket Set or 17mm Spanner
Lubricant or Grease
To Install the Litter Bin
(Ground Fixing).