GlammFire. PAG./
Fix the wall bracket using the plugs and screws provided - see
Fig. 3
.
Carefully lift the appliance up ensuring that the top rear ledge of the appliance engages the wall bracket and is cen-
trally positioned. - see
Fig. 4
.
A bottom fixing bracket is supplied. Fix this bracket to the bottom of the appliance using the silver screw on the under-
side. With the bracket in place mark the location of the hole on the wall. Then remove the appliance,drill the wall, fit
the wall plug and re-fit the appliance ensuring that you secure it in place by screwing the bracket to the wall.
Frame installation
1. To place the frame on the electric fireplace, tilt slightly and center the frame so that it enters between the respec-
tive protrusions'E' (see figure 7).
2. Once the frame has been inserted, insert the supplied screw so that the ring is properly fixed to the electric fire-
place (see figure 8).
4 - OPERATION
Manual Operation
The switches are located at the bottom right side of the appliance - see
Fig. 8
.
S1 - Power Switch.
S2 - Fire Operation Mode.
S3 - Downlight On/Off.
Remote Operation
The standby switch (S1) must first be turned ‘ON’.
NOTE: It takes some time for the receiver to respond to the transmitter. DO NOT PRESS the buttons more than once
within two seconds for correct operation.
Manual & Remote Operation
The standby switch (S1) must first be turned ‘ON’ to operate the appliance manually or by remote control.
Switch 2 (S2) of the appliance or the “I” button on the remote control operate the fire as follows:
Setting
Flame Effect
Flame Effect & 1kw Heat
Flame Effect & 2kw Heat
Operation
(Remote or S2 switch)
Press the
‘I’
button once
Press the
‘I’
button twice
Press the
‘I’
button three times.
Confirmation Light (Fig.6)
Top Neon
Middle Neon
Bottom Neon
Summary of Contents for Lum 1500
