5
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-800-247-1087 for further assistance.
Pre-Installation (continued)
FILTRATION SYSTEM OR
FILTRATION SYSTEM OR
FILTRATION SYSTEM OR
FILTRATION SYSTEM ORIENTATION
IENTATION
IENTATION
IENTATION
To operate properly, the system must
be installed with the sump pointed
straight down. When possible, install
the system on a horizontal section of
the household’s main incoming water
pipe. If the water pipe runs vertically
where you want to install the filter, buy
90° pipe elbows and plumb a detour.
Allow enough space under the system
(6 in. minimum) to remove the sump (to
clean or replace the filter screen).
Allow enough space above the system
to remove the top cover (to change
batteries, etc.).
REVERSING THE FACEPL
REVERSING THE FACEPL
REVERSING THE FACEPL
REVERSING THE FACEPLATE/DISPLAY
ATE/DISPLAY
ATE/DISPLAY
ATE/DISPLAY
The system must be installed with the water flowing into
the side marked IN. Remove the unit’s top cover and
observe the IN and OUT markings. Depending on the
direction of water flow and the viewing angle, the
faceplate may need to be reversed so that it does not
end up against a wall or other obstruction. This can be
done either before or after the filter is installed on the
plumbing:
1.
Remove the top cover by sliding it upward.
2.
With a Phillips screwdriver, remove the screws
holding the faceplate assembly to the filter head.
3.
Lift the faceplate assembly up and turn it around
180°, taking care not to pull on the wires between
the electronic control board and the valve
solenoid.
4.
Lower the faceplate assembly into place on the
opposite side of the head and reinstall the two
screws.
5.
Slide the top cover back on and push it down to
snap into place.
10 in.
min.
6 in.
min.
IN
OUT
House Water
Supply Pipe
Sump
Pointed
Straight
Down