11
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-800-247-1087 for further assistance.
Programming the Electronic Controller
POWERING UP
POWERING UP
POWERING UP
POWERING UP
When the controller is powered up (by installing the battery or plugging in the optional AC adaptor), the display will
briefly show the software version (example “1.0”), then the number of days until the next automatic sediment flush.
MANUALLY ST
MANUALLY ST
MANUALLY ST
MANUALLY STARTING A SEDIMENT FL
ARTING A SEDIMENT FL
ARTING A SEDIMENT FL
ARTING A SEDIMENT FLUSH
USH
USH
USH
After all installation steps have been completed, initiate
a manual sediment flush as follows:
1.
Press the CLEAN NOW button and hold it for at
least 2 seconds. When the 2-digit display changes
to show moving dashes release the CLEAN NOW
button.
2.
Check the drain hose to ensure a secure
connection.
3.
The sediment flush sequence takes about 30
seconds to complete. The flow of water to the
drain will start and stop several times.
4.
Once the sediment flush has been completed, the
2-digit display will change to show the number of
days until the next automatic flush (or if the
automatic flush feature has been turned off it will
show “- -”).
The filter can be manually activated to flush sediment at
any time, regardless of whether or not it is set to flush
automatically.
NO
NO
NO
NORMAL OPERATION
RMAL OPERATION
RMAL OPERATION
RMAL OPERATION
During normal operation, the LED will momentarily blink green every 8 seconds and the 2-digit display (LCD) will
show the number of days remaining until the next automatic sediment flush. Momentarily pressing the PROGRAM
button shows the setting for the number of days between flushes.
LCD BACKLIGHT
LCD BACKLIGHT
LCD BACKLIGHT
LCD BACKLIGHT
The 2-digit display has a backlight that goes on
whenever a button is pressed. It goes off again after 10
seconds if no more buttons have been pressed (to
conserve battery life). Momentarily press either the
PROGRAM or CLEAN NOW button to turn on the
backlight.
LED Color
LED Color
LED Color
LED Color
State of LED
State of LED
State of LED
State of LED
Shows when…
Shows when…
Shows when…
Shows when…
Green
Blinks every 8 seconds
The unit is in normal operation.
Amber
On steady
You are programming the controller.
Red
Blinks every 8 seconds
The battery is low.
None
Completely off
The battery is dead or disconnected.
Moving dashes
indicate sediment
flush is taking place
LED (see table below)
2-Digit LCD Display
(when unit is in normal
operation, LCD shows
number of days until
next automatic
sediment flush)