Installation
3-Option 3
4
Installing the slide bar
5
Installing the flange
□
□
Screw Installation
7
Insert the pipe (
J
) into the slide bar (
F
) as shown
below.
Tighten the set screw (DD) to secure the slide bar.
Insert the flange (
E
) into the slide bar.
NOTE:
You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
E
6-Option 1
Suction Installation
DD
J
CC
F
□
□
Turn the seat (
F1
) counterclockwise to remove it from
the slide bar (
F-shown on #4
).
Drill two 1/4" (7mm) holes in the wall which line up
with the seat (
F1
) screw holes. Push and secure
anchors (BB) into these holes.
Put the seat (
F1
) and the screws (AA), by order as
shown below, and fasten the screws (AA) to secure
the seat tight to the wall.
□
□
AA
BB
F1
F1
24.54
"
□
Push the top side of the slide bar onto the
connector (
D
), place the bottom part of the slide bar
onto the suction assembly (
I
) and rotate clockwise to
secure the bottom part tight to the suction assembly (
I
).
Tighten the set screws (DD) to lock the slide bar to
the connector as below.
NOTE:
You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
DD
CC
D
I
□
HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
