1
2
Installing the connector
□
Installing the 1/2" pipe nipple
Installation
3-Option 1
6
3-Option 2
□
Turn the seat (
F1
) counterclockwise to remove it
from the slide bar (
F-shown on #4
).
Put the tape (
G
) and seat (
F1
) on the wall by order
as shown below.
□
Apply
generous amount of
thread sealant tape(A) to
both threaded ends of the 1/2” pipe nipple,
B or C
;
whichever is needed for the application.
Suction Installation
Screw connector (
D
) in a clockwise motion onto
the outlet pipe nipple.
Tape Installation
NOTE:
This product includes two pipe nipples, but only one
will be used during installation. When installed, the nipple
should extend no more than 1/2" (12mm) past the finished
wall, and no less than 1/4" (7mm) past the finished wall. One
of the two included nipples should work for your application,
but if neither size works for your application, you can find a
variety of pipe nipple sizes at your local Home Depot store.
D
□
3/8±1/8
"
B or C
NOTE:
Make sure the wall is clean and there are no rough
surfaces and gaps on the wall.
G
F1
F1
23.34
"
25.74
"
□
Turn the seat (
F1
) counterclockwise to remove it
from the slide bar (
F-shown on #4
).
Push the suction assembly (
I
) and clamping
plate (
H
), by order as shown below, tight to the wall.
□
NOTE:
Clean the wall before installation and make sure the
wall’s surface is smooth (like glass wall or glaze tile).
H
I
F1
23.34
"
25.74
"
A
Hex key
