16
Operation
1
Flushing and checking for leaks
□
Remove the spray head by unscrewing it from
the hose in a counterclockwise direction, turn
the faucet to the warm position where it mixes
hot and cold water.
□
Flush the water lines for one minute. This flushes
away any debris that could cause damage to
internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the spray head tightly.
IMPORTANT:
After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
Problem
Possible Cause
Solution
There are leaks
underneath the handle.
The bonnet nut has come loose and the
o-ring on the cartridge is dirty or damaged.
□
Tighten the bonnet nut. Clean
or replace the o-ring.
The aerator leaks or has
an inconsistent water
flow pattern.
The aerator is dirty or misfitted.
The cartridge may be clogged.
□
Remove the aerator and check
for debris in the aerator screens.
□
Remove the cartridge and check
for debris.
NOTE:
Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
□
Ensure the aerator is properly
installed.
The water pressure is low. The aerator is clogged.
□
Turn off the water supply and
disconnect the aerator.
□
Unscrew the aerator and clean
under running water.
□
Screw the aerator back.
□
Test water flow. If water
pressure is still low then replace
the aerator.
There is no hot or cold
water.
The water inlet hose was acccidentally
kinked during installation and is limiting
the water flow through.
□
Reinstall the water inlet hose.
HOMEDEPOT.COM.MX
Please contact 01-800-00-4663-3 for further assistance.