7
Installation
1
Preparing for installation
CAUTION:
Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
30 in.
Tub & Shower
8 in. Min.
48 in.
Shower Only
1 1/4 in. Diamter
1 1/4 in. Diameter
48 in.
Tub & Shower
Refer to
the step 2
30 in.
Shower Only
D
2
Installing the valve body and
removing the plaster guard
□
Shut off the water supply to the tub and
shower.
□
Verify that the hole sizes and positions of the
holes in the wall are correct:
□
The shower and tub spout outlet holes
should be 1-1/4 in. diameter.
□
Refer to Step 2 for valve access hole
dimensions.
□
The recommended valve depth to the
finished wall is 2 in. min. to 3 in. max.
□
Ensure that the valve body (D) cover is flush
with the finished exterior surface of the wall.
Position the valve body (D) correctly in the
wall with the side marked "UP" pointing up. The
8 in. minimum from the valve body (D) to the tub
spout (J) is required for proper operation.
The plaster guard (L) is positioned so that it is
flush with the finished wall. This ensures that
the valve will be at the correct position to accept
the trim. The depth for the valve body (D) in wall
is measured from the center of the shower
outlet to the finished wall surface. The accepted
depth distance is 2 in. to 3 in..
□
Unscrew the screws (K), and remove the plaster
guard (L).
□
NOTE:
Be sure to position the valve body (D) correctly in
the wall, with the side marked "UP" facing upward.
2 in. to 3 in.
Finished wall
6 in. dia.
D
L
L
K
