Model # 75IECHK-SC-SP :Page 7
To prevent accidental tip hazard, dispenser must be securely anchored to wall as shown.
1. Place dispenser upright.
2. Locate dispenser on a hard and level surface in a cool
shaded location near a grounded wall outlet.
Notice: Do NOT plug in power cord yet.
3. Position dispenser so the back is at least 4 inches from
wall and there are at least 4 inches of clearance on
both sides.
4. Install Wall Mount Strap to prevent accidental tip over:
• Unclip strap from back of dispenser.
• Mount strap 25 inches up from floor directly to wall
stud with screw (See illustration A)
If stud is not available, insert and turn anchor directly
into sheet rock using a Philips screwdriver (DO NOT
drill hole into sheet rock first when using this anchor).
Secure strap by installing screw through washer,
then eyelet in strap and into wall mounted anchor.
(See illustration B)
• Position cooler in place.
• Clip strap onto back of cooler to right or left side.
(See illustration C).
• Adjust length of strap so the dispenser can
NOT move forward.
Note – Dispenser can be positioned in a corner but
still requires Wall Mount Strap to be installed.
Lengthen strap so that once installed the dispenser
cannot move forward.
This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT use
for other purposes. Warranty is void if used for any other liquids including coffee, tea,
juices, beer or wine.
This dispenser has been designed to use water bottles with 3 & 5 gallon capacity. Do
NOT use alternative bottles.
Initial Set Up
Notice: To prevent damage to compressor, allow unit to sit upright for at least 4 hours prior to
operating.
CAUTION
CAUTION
INSTALLATION
OPERATION
