Steps 6 to 9 covers advanced settings. These settings are not necessary, but can be used to adapt the zones for special
purposes. We recommend to thoroughly verify the function of the alarm zone if these settings are changed.
6.
Press "Advanced settings". Three new settings are shown.
7.
The sensitivity bar allows adjustment of the object detection sensitivity. Increased sensitivity can be used for applications
where highest detection is necessary, but will also slightly increase the risk of false alarms. Decreased sensitivity are
used for applications where the objects are big and slow, for example detection of boats.
8.
Alarm delay is a timer to allow a zone alarm to react if an object has stopped in the zone. Enter the time for which an
object must stay in the zone before the alarm is activated. Default value is 0 seconds, maximum is 2 minutes.
9.
Timeout specifies the time before a zone alarm resets after an object has been detected. This can be used to avoid extra
alarms from objects that creates multiple detections, for example masts on a boat. Default value is 0 seconds, maximum
is 2 minutes.
10. Press Add zone button to save the zone settings.
11. Repeat for each zone.
12. To edit a zone, press the zone name. Input fields appear on the right.
13. To remove a zone, press "Remove" next to the zone name. The zone and all actions for the zone will be removed.
5.4.2. Alarm zones actions
1.
Press "+ Add action" under the desired alarm zone. Input fields appear on the right.
2.
Choose action event type, "Relay action" or "Connect to URL". For relay action, go to point 5.
3.
Enter desired alarm enable URL, for example the VMS server.
4.
Depending on VMS, alarm disable URL may be needed.
5.
Press the save button to confirm settings.
6.
Repeat for each zone.
7.
To edit an action, press "Edit" next to the action in the list.
8.
To remove an action, press "Remove" next to the action in the list.
11
Summary of Contents for GJD515
Page 15: ......