operating this sander within the specified air pressure ranges.
The Air Regulator Function
Grip the body while press the lever.
Then switch the air regulator to turn the tool
“on”.
For faster r.p.m, turn the air regulator valve for air flow control from zero to
max.
Conncetion Of The Air Hose From The Compressor To The Tool
Check the air hose connection plug for small stone partcles and dust.
Foreign
Object Damage (FOD) can be caused by these small stone particles if they get into
the tool.
(1)
Prior to connecting the air hose, make sure that it is not damaged and the
connecting joint is tightly clamped.
Connect the air hose to the compressor and the
tool and make sure they aire air secure.
Test Run
CAUTION
Prior to switching on, make sure that the tool is not in contact
with the work piece.
This may damage the work piece or cause personal injury.
When switching on, the operator should be positioned away
from the exposed portion of the disc.
Before polishing, perform a test run with the sander.
Take care to
ensure that no one is in the immediate area during the test run.
During the test run, make sure that the tool is running normally and
that the pad disc is properly set.
WARNING
Turn the air regulator off and release the lever whenever
operations are interrupted, discs are changed, after
completion of polishing, and when the air hose is to be
disconnected.
Handle your sander with care.
Improper contact with other
materials may cause damage to the disc or to the sander.
Continuing polishing operations with cracked or damaged
discs is hazardous and could result in physical injury.
If the
polisher is dropped, perform a test run before resuming
operation.
Make sure that the tool is working properly
before continuing.
