eN
USER’S MANUAL
TC15
26
6.
TC15
APPLICATIONs
6.1 PrETArE
Without a weight on the plate to press the key
. Enter the pretare value using the numeric keypad. to remove the pretare, press
again
with empty plate.
6.2 wEIGhING MOdE
6.2.1
CONfIgURAtION Of tHE EqUIPMENt
See section Lf2 of the technical parameters
6.2.2
fIRSt CALIBRAtION
See section Lf1 dof the technical parameters
6.2.3
USE
Switch on the equipment when all the parameters have been correctly configured and the equipment has been calibrated.
Make sure than the value of the indicator, without load on the platform, is 0. If this is not the case, press
•
Place the weight on the platform and the platform will show the weight.
•
the accumulation of data
•
depend on the mode chosen in the section Uf-5.
You can display the accumulated values at any time by pressing
•
(
TOTALIZING)
6.3 PIECE COuNTING MOdE
6.3.1
CONfIgURAtION Of tHE EqUIPMENt
See section Lf2 of the technical parameters.
6.3.2
fIRSt CALIBRAtION
See section Lf1 of the technical parameters.
6.3.3
USINg A ExAMPLE (example)
Switch on the equipment when all the parameters have been correctly configured and calibrated equipment.
Ensuring that the value on the visor, with no load on the platform, is 0. If this is not the case press the key
.
Steps to follow
;
Place the example above the platform.
1.
Enter the number of example pieces and press
2.
.
the display unit weight calculated, indicating the number of pieces on the pan, until you press
3.
.
6.4 uSE uNIT wEIGhT
Switch on the equipment when the parameters has been configured correctly and calibrated the equipment.
Ensuring that the value on the visor, with no load on the platform, is 0. If this is not the case press the key
.
Steps to follow
;
Place the Unitary weight of the example and press
1.
. Consider the unit of the unitary weight.
the indicator calculates the number of pieces on the pan until you press
2.
.
Accumulating data
3.
will depend on the mode chosen in the Uf-5
It will be able to visualize the values accumulated at any time pressing
•
(
TOTALIZING
)
6.5 ALArM
When you configured the equipment 6.3 and 6.4, you place the maximum pieces that you desire to use on the plate and press
.
When the situation supered this value, the indicator will start to beep.
to deactivate the alarm, press hold on the key
until to listen a double beep.
6.6 MEMOrIZAr PLu
Configure the computer as described in the part 6.3 or 6.4.
Choose the memory bank where you save the PLU pressing the Key
and then press the Key
.
Choose the PLU desired.
Only stores data relating to unit weight.
6.7 MANuAL rE-AdjuSTMENT OF uNIT wEIGhT
You can automatically adjust the unit weight by pressing the key
, when you have entered the unit weight 6.3 o 6.4.
Summary of Contents for Baxtran TC15
Page 2: ......
Page 34: ...en USER S MANUAL TC15 34 ...
