44
Girard Systems
©
2005
4.
Ten feet (10') of gray low-voltage cable (black and red wires within) is provided to make
connection with wall mount switch. Connect black and red wires as follows:
a.
Hold wall mount rocker switch in vertical (up and down) position with black dot at
bottom.
b.
Hold wall mount paddle switch in vertical (up and down) position with the ground
screw on the bottom left-hand side.
c.
Rotate wall mount switch to reverse side (still in vertical position) and connect cable
wires, black above red, to the two terminals on back of switch.
5.
Install wall mount switch into switch box from front (pulling wiring through to back) using
screws provided.
6.
Install switch box faceplate using screws provided.
P.
g-1500 WALL MOUNT (paddle) SWITCH
(Electrical Installation)
1.
Run wall mount paddle switch cable wiring from switch box to junction box.
a.
Insert all the wires through wiring guide holes at bottom of junction box.
b.
Connect wires as follows:
1) Brown wire (B1): from paddle switch to black wire from Somfy motor.
2) Red wire (A1): from switch to red wire from Somfy motor.
3) Black wire (L1): from paddle switch to black wire from main power source.
4) White wire: from Somfy motor to white wire from main power source.
5) Green ground wires (3): connect wires from switch box, Somfy motor, and main
power source to each other, ground to junction box, and then secure all connections
with pigtail.
(See Wiring Diagram, Fig. 31)
Summary of Contents for G-Link G-1500
