Page 6 of 11
PROGRAMMING
The following pages give instructions of how to pair the 98GC230 with various motor
controllers. Ensure that you select the correct set of instructions for the motor controller
on your vehicle.
GC136 AC Motor Controller
Fig.1 Fig.2
To pair the 98GC230 Wall switch with a GC136 Motor controller follow the steps below.
Note; When carrying out this part of the procedure each step must be
executed within 10 seconds of the previous one or the module will revert to
factory settings. It is highly recommended that you read and understand the
following sequence before attempting to execute it.
1)
Ensure that there is power supplied to the Motor controller.
2)
Using an appropriate tool press the Program button on the Motor controller. See
Fig.1 (The Green LED will start blinking)
3)
Press the STOP button on the Motor Controller. See Fig.2 ( The Green LED will
remain ON)
4)
Press the IN button of the desired channel on the Wall switch. (The Green LED
will extinguish)
5)
Press the OUT, STOP and IN buttons on the wall switch to ensure that the
Modules have been successfully paired.
Program Button
Stop Button
