Window actuator flush-mounted
Order-No. : 2164 00
Blind actuator 1-gang flush-mounted
Order-No. : 2165 00
Heating actuator 1-gang flush-mounted
Order-No. : 2166 00
Operating instructions
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
The device is not suitable for disconnection from supply voltage.
The connected actuators are not electrically isolated from the mains – even when
switched off.
Do not connect any external voltage to the inputs, since doing so may damage the
device(s), and the SELV potential on the KNX bus line will no longer be available.
For parallel connection of several drives to an output it is essential to observe the
corresponding instructions of the manufacturers, and to use a cut-off relay if necessary.
There is otherwise risk of irreparable damage to the drives.
Use only shutter drives with mechanical or electronic limit switches. Check the limit
switches for correct adjustment. Observe the specifications of the motor manufacturers.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
Figure 1: Window actuator
1/8
32572302
20.05.2011
10499188 I00
KNX/EIB
