Connecting the evaluation unit
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before working on the device, disconnect all the corresponding miniature
circuit breakers. Cover up live parts in the working environment.
o
Remove the housing lid of the evaluation unit by slackening the two screws (3).
o
For rear cable insertion, penetrate the rubber seal (6) and insert the cable (Figure 3).
Figure 3: Evaluation unit connection compartment
o
Fasten the device using two screws (10).
o
Insert the cables into the connection housing and connect the according to the connection
diagram (Figure 4).
o
If multiple miniature circuit breakers supply dangerous voltages to the device or load,
couple the miniature circuit breakers or label them with a warning, to ensure release is
guaranteed.
i
Terminals 1 and 2 serve as distributor terminals and are not connected inside the device.
They can be used, for example, for a heated wind sensor.
i
The distributor terminal (5) serves to connect the protective conductor.
82523842
07.08.2014
3/6
Blind control system
Wind sensor Standard
