-
Several repeaters can be installed in a single system, e.g. two transmitters
A + B
transmit
to a single actuator
C
(Figure 3)
-
Indication of the operating states via 2 LEDs:
Red LED lights up briefly: receiving a telegram
Green and red LEDs light up briefly: a taught telegram is being relayed
Red LED flashes continuously: repeater is in programming mode
Figure 4
i
Cascading of repeaters is not possible, i.e. telegrams transmitted by a repeater will not be
repeated by another repeater (Figure 4).
4 Information for electrically skilled persons
4.1 Fitting and electrical connection
Mounting and connecting the device
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before working on the device, disconnect the power supply and cover up live
parts in the working environment.
Protection rating IP 54 or IP 20, depending on the type of installation:
IP 54 = fixed connection with NYM-J 3x1.5 cable and antenna not routed out of the device.
IP 20 = connection with supplied mains cable and/or antenna routed out of the device.
Maintain a distance of at least 0.5 m from metal surfaces and electrical devices, e.g. microwave
ovens, hi-fi and TV systems, electronic ballasts or transformers.
Mount repeater as close as possible to the middle of the desired transmission path.
o
Slacken screws (5) and remove housing lid (4).
The
TOP
label on the rear of the housing has to be at the top.
If the repeater is intended to amplify the radio telegrams of a stationary transmitter, the teaching
procedure for the radio transmitter should be performed before installation (see Commissioning
chapter).
82530522
24.10.2016
3/5
Radio bus system
Radio repeater
