Ginnys.com • 1.800.544.1590
CARE & MAINTENANCE
Moving your appliance:
• Remove all of the food.
• Turn the leveling screws up to the base to avoid damage.
• Tape the doors shut.
• Be sure the appliance stays in the upright position during transportation.
NOTE: If the appliance is tilted for an extended period of time, follow the instruc-
tions on p. 5 (Before Using Your Appliance).
REVERSING DOOR SWING
The side at which the door opens can be changed from the left hand side (as
supplied) to the right hand side, if the installation site requires. Should you
require the reversal of the door opening direction, please follow the instructions
on the following page.
Before reversing the door swing, ensure the appliance is unplugged and empty.
Provide additional support for the doors while the hinges are being removed.
• Do NOT depend on the door magnets to hold the door in place. It is recom-
mended that two people perform this task.
• Do NOT lay the appliance completely flat as this may damage the cooling
system.
1. Top hinge cover
2. Top hinge screw
3. Top hinge
4. Cabinet plug
5. Bottom hinge
6. Door handle plug
7. Bottom hinge screw
8. Leveling leg
REVERSING DOOR SWING
1. Tilt the appliance slightly (not more than 45°) towards the rear and prop it
securely. Two people are required to tilt the unit during the door reversal
process.
2. Remove the top hinge cover (1) and unscrew the three top hinge screws
(2) that are beneath it. Then remove the top hinge (3).
3. Remove the cabinet plug (4) and the door handle plug (6).
4. Remove the door.
5. Remove the right and left leveling legs (8).
6. Remove the bottom hinge (5) and unscrew the three bottom hinge screws
(7).
7. Screw the bottom hinge (5) to the reverse side of the freezer with the
three bottom hinge screws (7).
8. Replace the right and left leveling legs (8).
9. Place the door back on the freezer, making sure it is aligned horizontally
and vertically so that the seals are closed on all sides.
10. Screw the top hinge (3) to the reverse side of the freezer with the three
top hinge screws (2).
11. Place the top hinge cover (1) over the top hinge.
12. Install the cabinet plug (4) and the door handle plug (6) on the reverse
side.
13. Adjust the leveling legs.
