TROUBLESHOOTING
10
Ginnys.com 800-544-1590
SEALER HAS NO POWER
• Make sure the vacuum sealer is plugged in.
• Check the power cord and plug for damage. If damaged, DO NOT use the
sealer.
• Test the electrical outlet by plugging in another appliance.
• The vacuum sealer will shut off automatically if overheated (lights will
flash). Allow the sealer to cool down for 10 minutes before trying again.
SEALER DOES NOT PERFORM FIRST SEAL ON THE BAG
• Make sure the bag cut from the roll is properly positioned as described on
page 6.
SEALER DOES NOT COMPLETELY VACUUM AIR FROM BAGS
• To seal properly, the open end of the bag should be dry and resting entirely
inside the vacuum chamber.
• Check the bars and gaskets for debris. Wipe clean and smooth them back
into place.
• Bag may have a leak. To test, seal the bag with some air in it, submerge it
in water and apply pressure. Bubbles indicate a leak. Reseal or use another
bag.
BAG IS NOT SEALING PROPERLY
• The heating bar may overheat and melt the bag. If this happens, lift the lid
and allow the bar to cool for a few minutes.
BAG LOSES VACUUM AFTER BEING SEALED
• Leaks along the seal can be caused by wrinkles, crumbs, grease or liquids.
Reopen the bag. Wipe the top inside of the bag and smooth it out along
the sealing strip before resealing.
• Check the bag for punctures or holes.
