=
3
3
1
1
2
2
Set the clips on both sides of
the hole
with screws and plugs,
maintaining alignment with the
guides. Insert the mosquito
screen package into the ope-
ning, snap it into place with the
hooks and side clips. Open the
package and install the closing
profile on the opposite side in
the same way.
Remove the magnet from the closing
profile
Inside you will find the upper and
lower tensioners of the operating thread
system. Move the tensioners until the
correct tension is achieved and fix them
with the set screw.
If necessary,
individual adjustment of the threads
can be carried out using the tensioners of the fixed
profile in the screen package whilst the screen is
folded in.
* Once the tension of the wires has been adjus-
ted, replace the magnet, taking the polarity of the
magnet into account.
For the assembly follow the steps for both sides:
1 I 2 I 3 I 4 I 6
Setting the compensator
with screws and plugs in the upper
part of the opening. Move the hooks
5
to the ends of the upper
guide and lock by tightening the set screw.
Attach the lower guide to the floor
with the bi-adhesive, taking
care to keep the guide aligned with the top guide. Move the hooks
4
to the ends of the lower guide, fix them to the wall with screws
and plugs.
For the assembly follow the steps:
1 I 2 I 3 I 4 I 5 I 6
For the assembly follow the steps:
1 I 2 I 3 I 4 I 5
2 Lateral 2 leaf
3 Reversible
Step 4
Step 5
Step 6
Step 1
Preparation of the guides:
insert hooks
5
in the upper guide and
hooks
4
in the lower guide.
Step 2
Step 3
1 Lateral 1 leaf
1
1
1
5
5
5
3
3
7
7
4
4
4
6
2
2
2
8
7
8
6
ASSEMBLY MANUAL
PLEATED MOSQUITO SCREEN 27 LATERAL AND REVERSIBLE
