12
The aerosol is programmed initially for level 1 (low level of nebulisation).
According to indications given by a therapist, the operator may select level 2 or level 3 (the maximum level
of nebulisation) by pressing the respective nebulisation commands. By pressing the button repeatedly,
level 2 or 3 may be selected or level 1.
After use press the stand-by button in order to stop nebulisation. The switch on the side is used to turn
the aerosol off.
Warning:
Do not put the air nozzle directly in your mouth. Use the accessories recommended
with the air nozzle.
Third step: after each use
1. Remove the plug of the aerosol
2. Carefully remove the medicine container and dispose of the medicine left over
3. Empty the water tank
4. Dry the product in the best possible way
PROBLEM SOLVING
In the event of a fault, check and correct as follows:
Conditions
When I press the ignition button of the
device it does not turn on
The device is on but it does not nebulise
or nebulisation is poor
The device is on but the fan does not
work correctly
Solutions
- Make sure that the plug has been correctly inserted into
the wall
- Check that the water level in the tank is as indicated by
the relative marker
- Check that the medicinal product is in the container.
- Check that the medicine container is not damaged.
- Check that the transducer is clean
Check that the fan has been correctly fitted and fixed to
the motor shaft
Disposal:
The product must not be disposed of along with other domestic waste. The users
must dispose of this equipment by bringing it to a specific recycling point for electric and
electronic equipment.
For further information on recycling points contact the local authorities, the local recycling
center or the shop where the product was purchased. If the equipment is not disposed of
correctly, fines or penalties may be applied in accordance with the national legislation and
regulations.
GIMA WARRANTY CONDITIONS
Congratulations for purchasing a GIMA product.
This product meets high qualitative standards both as regards the material and the production. The
warranty is valid for 12 months from the date of supply of GIMA.
During the period of validity of the warranty, GIMA will repair and/or replace free of charge all the defected
parts due to production reasons. Labor costs and personnel traveling expenses and packaging not
included. All components subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized personnel or with non-
original spare parts, defects caused by negligence or incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or software due to outside
agents such as: voltage changes, electro-magnetic fields, radio interferences, etc.
The warranty is void if the above regulations are not observed and if the serial code (if available) has
been removed, cancelled or changed. The defected products must be returned only to the dealer the
product was purchased from. Products sent to GIMA will be rejected.
ENGLISH
