6/6
PIPETMAX ALIGNMENT UTILITY
|
INSTRUCTIONS
Reconnect External Safety Interlock Sensor
If your PIPETMAX does not have a rotating cover, it requires
an external safety interlock. The external safety interlock was
disconnected prior to running the alignment. Reconnect the
BOTTOM terminal block connector to the input/output ports on
the rear panel.
Troubleshooting
If you see the following message, remove and reinstall the removable tray and then rerun the
PIPETMAX Alignment Utility.
If you encounter any trouble or have concerns while running the alignment, please do not
hesitate to contact your local Gilson representative. Specific contact information can be
found at
www.gilson.com/contactus.
Figure 7
External Safety Interlock
Sensor Connections
