www.gillathletics.com
Copyright
2021 by Gill Athletics.
All rights reserved.
800-637-3090
2/18/2022
INST730181
Page 2 of 3
730181 - FUSION 4x8 STARTING BLOCK
INSTRUCTIONS
M8 x 16mm Flat Head Cap Screw
Rail
Handle
The FUSION starting block is shipped unassembled.
The following tools are needed:
- Needle Nose Pliers
- Spike Wrench
- Allen Key (provided)
1. Pedal pads
Set the angle of the pedal to the 60 position.
Insert the tabs on the pedal pad into the holes in the pedal plate.
Use one hand to press on the pedal pad. Use the other hand to
gently pull the tabs through the holes with needle nose pliers.
Gently wiggle the tab to help it through the hole. Be careful not
to pull the tab off of the pedal pad.
2. False start bracket
Fasten the false start bracket to the back of the rail with the
flat head screw provided.
Make sure that the "teeth" of the rail are pointing away from
the false start bracket.
3. Pedals
Slide each pedal onto the rail so that the pedal pad is facing
towards the open end of the rail.
Fasten the handle to the front of the rail with the flat head
screw provided.
4. Handle
Flip the starting block over and install the spikes into the
bottom of each pedal.
5. Spikes
Pedal Plate
Pedal Pad
False Start Bracket
Rail
M8 x 16mm Flat Head Cap Screw
