Contents
MetPak RG User Manual
©
Gill Instruments Ltd
Last Change
Page 20
12 February, 2013
6.
Tighten the gland on the connection ports to seal the cables in place.
Replace the top on the connection box.
7.
If you are carrying out a bench test, continue to step 13. When you have
finished testing, return to Step 10.
8.
Ensure that if using a mounting pole that it has been degreased in the area
where the MetPak RG will be positioned.
9.
Position the MetPak RG against the mounting post (see page 15), fit the
mounting kit bracket and tighten sufficiently to hold the unit in place but
allowing it to be rotated or moved up and down the pole.
10.
Check the orientation and alignment of the unit (see page 14).
11.
Check the height of the unit and ensure it is clear of any obstructions,
including the mounting post, that could interfere with MetPak RG’s
measurements (see page 14).
12.
Tighten the mounting bracket nuts evenly to a toque figure of 3Nm to hold
the unit firmly in place.
13.
Connect the communications cable to your PC or network device.
14.
Place the MetPak RG CD in your PC’s CD drive and install MetSet and
MetView.
