Gilbarco PA025800 Series, Installation And Service Instructions Manual

Page: 13 / 22

MDE-2597L Gilbarco® Security Module (GSM) PA0258XXXXXXX Installation and Service Instructions · January 2010 Page 13
Installation
11
Using a permanent ink marker, write the month, day, and year of installation in block letters on
the front product label (see
Figure 3 ).
Figure 3: Front Product Label
MONTH DAY YEAR
INSTALL
DATE
UP
THIS UNIT FOR
Mobil
ONLY
12
Verify correct debit card processing by attempting a debit card transaction at the CRIND
device. Refer to
“Testing and Troubleshooting” on page 21 .
Connecting the GSM to Passport (V3.6 to V8.0)
To connect the GSM to the Passport system, proceed as follows:
1 Connect a 9-pin RPCI Gender Mender (Q13180-04B) to the GSM (see Figure 2 on page 11 ).
2 Connect one end of a CAT-5 Cable (Q13482-XX) to the 9-pin Gender Mender (Q13180-04B)
and run the other end to the Passport Server Edgeport Device.
3
Connect the CAT-5 Cable (Q13482-XX) to a 9-pin Gender Mender (Q13180-20B), then
connect Q13180-20B to the COM 3 position on the Passport Server Edgeport Device
(see Figure 2 on page 11 ).
4
Connect the power module to the GSM.
5
Insert the GSM power module outlet cord into the outlet.