MDE-2597L Gilbarco® Security Module (GSM) PA0258XXXXXXX Installation and Service Instructions · January 2010
Page 11
Installation
Connecting the GSM to PC G-SITE Controller
To connect the GSM to the PC G-SITE Controller, proceed as follows:
1
Connect a 9-pin RPCI Gender Mender (Q13180-04B) to the GSM (see
).
Figure 2: Connecting the CAT-5 Cable
PA02580000XXX
OR
PA0258000TXXX
PC Based G-SITE POS System
Q13180-04B
Q13180-20B
M09747B010
Q13180-63B
5’
5’
Power Module
Q13698-03
Part of
PA02580000XXX
Passport Edgeport
USB to RS-232 Converter
Passport Enhanced Dispenser
Hub PA04030000
2
Connect one end of the CAT-5 Cable (Q13482-XX) to the 9-pin Gender Mender and run the
other end to the PC G-SITE Controller.
3
Connect the CAT-5 Cable (Q13482-XX) to the appropriate position on the G-SITE Controller
(see
).
4
Connect the power module to the GSM.
5
Insert the GSM power module outlet cord into the outlet.
Note: Power must be applied to the GSM before it is applied to the Controller.
