Page 8
MDE-4780D FlexPay™ EPP and SCR Kit (EPK ECIM RF) Installation Instructions for Encore® S E-CIM™ · December 2015
Installing FlexPay EPP Kit
3
Remove the grade select buttons by pushing down from the top of the soda button while
pulling from the bottom of the soda buttons. The grade select bases will remain in position.
Note: Be careful not to dislodge the magnets.
Figure 1: Removing Grade Select Buttons
Grade Select Buttons Removed
4
Isolate the CRIND two-wire cable.
5
Remove the brand panel graphic using a flat-blade screwdriver.
Figure 2: Removing Brand Panel Graphic
(i)
(ii)
(iii)
6
Clean residual glue, if any.
