Gigaset A540, Manual

Page: 29 / 80

en ar 27
Gigaset A540 / en / A31008-M2601-A701-1-UZ19 / appendix.fm / 31.07.2014
A-K
lasse
_La
you
t_
Ne
u, V
e
rsi
on
4
, 28.05
.2
014
Manufacturer's advice
Kuwait
Customer Service Hotline Kuwait
Tel: 00965-22458737 / 00965-22458738
Al-Baptain Service Center
Shop #: 247
Qibla, Block 11,
Avenue 11,
Souk al Kabeer,
Fahad Al Salem Street,
Tel: 00965-2464993
Jordan
SEDR Home & office Electronics
Co - Tronicom
Wasfi Al-Tal St.,
Building No. 80,
2nd floor,
Tel: 00962-6-5625460/1/2
Lebanon
306, Jdeideh Sin el Fil Blvd,
Tel: 00961-1240259 / 00961-1236110
Questions and answers
Suggested solutions are available on our website at
www.gigaset.com/service
The table below also lists steps for troubleshooting.
The display is blank.
• The handset is not switched on:
¤
Hold down the End call key
a
.
• The battery is empty:
¤
Charge the battery or replace it (
¢
page 6).
• The key and display lock is activated:
¤
Hold down the hash key
(
.
"Base" flashes on the display.
• The handset is outside the range of the base:
¤
Move the handset closer to the base.
• The base is not switched on:
¤
Check the base power adapter.
• The base's range has decreased because Max. Range is deactivated:
¤
Activate Max. Range (
¢
page 17)
or
¤
reduce the distance from handset to base.
"Register handset" or "Place handset into base" flashes on the display.
• The handset has not yet been registered or was de-registered due to the registration of an additional
handset (more than 4 DECT registrations):
¤
Register the handset again (
¢
page 7,
¢
page 18).
The handset does not ring.
• The ringtone is deactivated:
¤
Activate ringtone (
¢
page 21).
• The phone does not ring if the caller has withheld his/her number:
¤
Activate the ringtone for anonymous
calls (
¢
page 22).
• The telephone does not ring during a specific time period:
¤
Check the time control for external calls
(
¢
page 22).
No ringtone/dial tone from the fixed line network.
• The telephone cable supplied has not been used or has been replaced by a new cable with the wrong pin
connections:
¤
Please always use the telephone cord supplied or ensure that the pin connections are
correct when purchasing from a retailer (
¢
page 30).
The connection always terminates after approx. 30 seconds.
• A repeater (earlier than version 2.0) has been activated or deactivated (
¢
page 19):
¤
Switch the handset
off and back on again (
¢
page 8).
Error tone sounds after system PIN prompt.
• The system PIN you have entered is incorrect:
¤
Repeat the procedure, reset the system PIN to 0000 if
necessary (
¢
page 23).
Forgotten system PIN.
•
¤
Reset the system PIN to 0000 (
¢
page 23).
The other caller cannot hear you.
• The handset is "muted":
¤
Reactivate the microphone (
¢
page 10).